Cooling Tower Parts and its’ Functions

In this article, we are going to discuss Cooling Tower Parts and its’ Functions like what is Cooling Tower Parts and how they are work in detail. Guide


Cooling tower

Cooling towers are a special sort of device that permits water and air to return in touch with one another to lower the temperature of the recent water.

During the cooling system working process, small volumes of water evaporate, lowering the temperature of the water that’s being circulated throughout the cooling system.

Cooling Parts & Functions


Here is a list of the most common cooling tower parts that might need to be repaired or replaced during the life of your cooling tower.

Cooling Tower Fill Media

Fill media is by far one of the most important cooling tower parts. It could be considered the middle man of the entire process. Many of today’s cooling towers use efficient film fills or fill media that maximize the area for evaporative cooling processes.

This process increases the water-air interface and allows extra heat to evaporate at a quick pace. The major factors in choosing fill media are TSS levels or Total Suspended Solids, intended treatment, water make-up, and contamination potential.

Also, LearnTypes Of Insulation Resistance Test And Its’ Working

The 2 basic sorts of fill media are film type fill media (spreads the water out into a skinny layer) and splash type fills media (breaks the water up). There is also fill media for specific sorts of towers like crossflow fill media and counterflow fill media.

Cooling Tower Parts and its' Functions


Cooling Tower Instrumentation


Cooling Tower Instrumentation systems usually include Flow Meters For Cooling Tower Makeup Water, Blow Down Rate, Water Level Switches For Cold & Hot Water Basins, Thermocouples for Cold & Hot Water Measurement Of Temperature, Vibration Switches and Low & High Oil Level Switches.


Cooling Tower Drift Eliminators

What are cooling tower drift eliminators used for? Cooling tower drifts eliminators and heavy-duty drift eliminators are parts of a cooling system that are designed to get rid of droplets of water from the air and minimize loss of process water.

Drift eliminators cause the droplets and air to change direction suddenly. This process causes the water to become separated from the air and replace it into the cooling system.
Cooling Tower Nozzles

Cooling Tower Fans

What are cooling tower fans used for? Cooling tower fans are wont to force or push large amounts of air throughout the cooling system.

They must be built to withstand the corrosive effects in which the environment that they operate. These fans are usually loud but there are certain sorts of low-sound cooling system fans. Cooling tower fans are utilized in crossflow, counterflow, induced/forced draft cooling towers.


Fan Deck & Fan Cylinder

The deck of the fan is a supporting platform for cylinders of the fan, which also makes an access way to the fan and water distribution system.

Automatic Water Level Controls

Water Level Controls or float switches are manufactured to control water levels automatically. This helps ensure there is always the correct amount of water inside your storage tank.

The level controls are typically used to automatically fill water and stop the fill once it reaches the adequate height. These controls can also be installed with LED sensors that will let you know when your levels are getting too low or too high, called high and low-level alarms.

“Automatic water level controllers switch the motor on whenever the water level drops below a particular level and shuts the motor off when the water rises well above a fixed level.” Water Level Controls

Cooling Tower Parts and its' Functions


Piping For Water Distribution:


Piping, for water distribution in a cooling tower, is buried underground and should be supported in-ground to prevent thrust loading in the cooling tower because of self-weight and water pressure in the pipe.


Air Inlet


These louvers also lower the quantity of splash-out, which lowers the quantity of water and chemical use. Also, you’ll experience easier basin removal and access.

The air inlet louvers in counterflow towers can sometimes become scaly if they are not correctly maintained and cleaned. Scaled louvers lessen the quantity of air-flow which lowers the efficiency of the unit.


Leave a Reply

Your email address will not be published.